ZyXEL Communications ZyWall - Page 18

18/26
www.zyxel.com
No traffic flow through site-to-site IPSec VPN tunnel
Tunnel established but can’t get traffic across:
 Make sure there are no IP conflicts between the two sites.
 Disable the ZyWALL routers firewall.
To disable the ZyWALL’s firewall/policy control, go to:
Configuration  Firewall OR Configuration  Security
Policy  Policy Control
 Verify that the host you are attempting to reach is pointing to the
ZyWALL for the default gateway.
 Check for conflicting policy/static routes. A misconfigured or
out of order route can cause problems. To verify the
policy/static route rules go to, Configuration  Network 
Routing.
 Verify that the host you are attempting to reach is listening for the
traffic you are sending to it. Example: If you’re sending a ping
request to a device, make sure it is set to respond to ping/icmp
requests.
Windows: Open command prompt or powershell and type
netstat -an for a list of listening ports.