12
Loading a USB (Support MP3 File)
1. Connect power and press the button to turn on unit .
2. Insert the USB device into the USB jack for a few seconds the unit will be
start playing.
3. Set to USB mode, press the FUNCTION until ”USB indicator show on
display and the USB will be auto play and the track number show on
display. If necessary, press the button to begin playing the USB.
4. Make sure the VOLUME knob is not correct position.
5. When removing USB device, first press the button to stop playing.
Play / Pause Control
1. When USB memory stick connected. Press the button to play the
USB.
2. Pause playback temporarily by pressing again the button. Music
playback will be paused and the current elapsed track time will be shown
and blanking on the display.
3. Press the button again to resume playback.
Stop Playback
To stop playback, press the button to stop playback.
Skip Track
During playback, press the buttons to skip to the next or previous
tracks.
During playback, press the +10 buttons to search the tracks by ten.
High-Speed Music Search
1. During playback, tuning and hold the USB SKIP/SEARCH buttons
to skip/search through the current track at high speed in forward or
backward directions.
2. When the USB SKIP/SEARCH buttons are released, normal
playback speed will be resumed immediately.
Repeat Function
During the disc playing.
Press the REPEAT button once and “REP 1” indicator light on display. The
unit will play the current track repeatedly.
Press the REPEAT button three time and “REP ALL” indicator light on
display.. The unit will play the entire disc repeatedly.
To cancel the repeat function: Press the REPEAT button repeatedly until
the “REPEAT” indicator light off or press the button twice to stop.
LISTENING TO USB DEVICE
To Next Page
Loading...
