System Control
AT&Bxx=DOWN – Transfer of GSM board xx into the sleep mode
AT&BPR=DOWN – Transfer of PRI board into the sleep mode
AT&BALL=DOWN – Transfer of all GSM boards into the sleep mode
AT&Bxx=RESET – Reset of GSM board xx
AT&BPR=RESET – Reset of PRI board
AT&BALL=RESET – Reset of all GSM boards
AT&BSYS=RESET – Reset of PRIGW
AT&Gxx=RESET – Reset of GSM module xx
AT&Gxx=BLOCK – Block of GSM module xx
AT&Gxx=DOWN – Transfer of GSM module into the sleep mode
AT&Gxx=ON – Transfer of GSM module into the idle mode
ISDN PRI Board
AT%I00= – ISDN PRI port type (TE/S; TE/M; NT/S; NT/M) or VoIP = SIP
AT%I01=x,y
X – TEI ISDN PRI connections (0–63)
Y – CRC (0=off, 1=on)
AT%I05=c1,c2,c3,c4 – Number of causes sent to ISDN PRI (in
ReleaseComplete) whenever an incoming call from ISDN PRI is rejected
AT%I11= – MSN for remote control via PRI 1
AT%I12= – MSN for remote control via PRI 2
AT%I04=x,y – Channel select for PRI 1 / PRI 2
AT%I06=c1,c2,c3,c4 – Progress messages
AT%i09=day,bits,enb
Day – day of statistics reset
Bits
0 – no dial tone
1 – continuous
3 – discontinuous
Basic GSM Settings
AT%G00=rr,gggggg,gggggg, gggggg,gggggg,gggggg – g,r = Number of
GSM group for each GSM module
AT%G01=mode,atms,atfs – Voice processing settings (for GM22 GSM modules
only)
mode – algorithm (0-none, 1-semiduplex, 2-fullduplex)atms,
atfs – transit, receive gain (3=+5dB, 1=+2.5dB, 0=0dB, 2=-2.5dB,
4=-5dB
AT%G02=mode,atms,atfs – Voice processing settings (for TC35 GSM modules
only)
mode – algorithm (2-echo canceller)atms,
atfs – transit, receive gain (3=+5dBm, 1=+2.5dB, 0=0dB, 2=-2.5dB,
4=-5dB
AT%G06=mmdd,…mmdd… – List of holiday days (mm-month;dd-day), max
length of line is 63 chars!
AT%G07=mmdd,…mmdd – Net list of holiday days
AT%G08=delay,min,max,tout – Parameters of dialling from ISDN to GSM
delay – relax delay between calls
min – minimum length of number dialled from ISDN
max – maximum length of number dialled from ISDN
tout – delay between dialled digits
To Next Page
