5.4 List of LOG Events
Table of LOG events:
Type Text Description
POWER [Power on] System switched on
[Power off] System switched off
[Warm boot] Restart of system, unknown cause
[Watchdog] Restart of system by watchdog
[BKPT code] CPU error: break code detected
[Stack error] CPU error: stock integrity failure
[Divided by zero] CPU error: dividing by zero
[RETI code] CPU error: illegal using of instruction reti
[NMI intr] CPU error: wrong interrupt
[VOID intr] CPU error: wrong interrupt
[Upgrade reset] Start of upgrade firmware procedure
[Software reset] Reset by AT commands (at&fres…)
INIT Eeprom Initialisation of eeprom (configuration)
Flash Initialisation of flash memory (firmware)
HW-ERR
(##…address of chip, RD…read value/WR…expected
value)
Codec ##, RD/WR Error in initialisation of codec on GSM,AUX board
Duart #####,
RD/WR
Error in initialisation of serial controller on GSM
board
Hscx #####,
RD/WR
Error in initialisation of HDLC controller on AUX
board
Pri #####, RD/WR Error in initialisation of PRI controller
SYSERR User stack error! SW error: stock integrity failure
BRDIN #08 TYP STS Board inserted (number of gsm board, type, status)
BRDOUT #08 TYP STS Board disconnected
BRDRES #08 TYP STS Reset the board by AT command
ALL GSM RESET
CMD
Reset all GSM boards by AT command
SYSTEM RESET CMD Reset the system by at&bsys command
To Next Page
Loading...
