EasyManua.ls Logo

2N stargate - Page 160

2N stargate
190 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1602N TELEKOMUNIKACE a.s., www.2n.cz
®
new – number of received and saved MS on SIM card
cnt – total number of sent SMS messages according to statistics
*smsinc: ch,ix,sts,mem SMS message has been received and saved
ix – index number of saved SMS (0–250)
sts – status of SMS (from +CMGL: ix.sts.len)
mem – type of used storage (1,2,3)
*smsrep: ch,ix,sts,mem SMS status confirmation has been received
sts – reserved (0)
*smsout: ch[/id],ref,req – SMS message was sent and not saved to SIM card
ref reference number of SMS (0–255) – to be used in status confirmation
messages
ID – third party identification number of SMS
*smspdu: ch,ix,sts,len,pdu,csum Content of SMS message
len length of SMS message (number of bytes in PDU)PDU content of
message in PDU format
csum – checksum of all PDU bytes (2 hexa digits) calculated without carry
*smsdel: ch,ix SMS message deletion confirmation
*smserr: ch[/id],ix,req,err,cms Fault command response, or SMS not sent
req – required wireless engine or GSM group
err – error code (6-busy,40-write,41-read,42-delete,43-list)
cms – error cause from wireless engine
*smssel: ch,cnt – SMS storage change confirmation
AT^SX=ch SMS listing request for listing of all SMS messages and status
confirmations saved on SIM card. Possible answers:: *smserr (busy,list) or
*smsinc (ix=1..255) for each saved SMS or status SMS , end of list or empty SIM
card – *smsinc (ix=0).
AT^SR=ch.ix SMS read request for reading of an SMS message or SMS
status saved on SIM card. Possible answers: *smserr (busy,read) or *smspdu
AT^SD=ch,ix SMS delete request for deletion of an SMS message (or SMS
status message). Possible answers: *smserr (busy,delete) or *smsdel
AT^SM=ch,len,pdu,chsum SMS to module request for sending a message
via GSM module 0..31 or via any GSM module (ch=32). Possible answers:
*smserr (busy,write) or *smsout
AT^SG=grp[/id],len,pdu,csum SMS to group request for sending an SMS
message via GSM group 1..8. Possible answers: *smserr (busy,write) or *smsout
AT^SS=ch,mem Command for changing SMS storage. Mem (1;2;3) = type of
SMS storageSiemens:1=SM, 2=ME, 3=MEEricsson:1=SM, 2=ME,
3=MEWavecom:1=SM, 2=ME, 3=SR Huawei:1=SM, 2=SM,
3=SMSierraWir.:1=SM, 2=ME, 3=SRMotorola:1=IM, 2=IM, 3=IM

Other manuals for 2N stargate

Related product manuals