The GSM gateway factory configuration allows you to make outgoing calls without
any additional programming. All you have to do is set the correct values for the
PRI ISDN and VoIP interfaces.
From now on, will be ready to receive VoIP/ISDN calls2N StarGate / BlueTower
®
and route them to GSM/UMTS networks. If all the GSM modules are occupied, or
logged out, the GSM gateway will reject all VoIP/ISDN and GSM/UMTS calls.
Should you get in troubles, follow the steps below please:
Read the User Manual carefully and check all parameters.
Find answers to the frequently asked questions at .http://faq.2n.cz
Consult your servicing partner.
You are recommended to attend a 2N certified training to improve your installation
chances.
To Next Page
Loading...
