Application Toolkit services for the Telit HE/GE 910 modules.
Disconnect Call
Set the rules for automatic disconnection of outgoing calls to a wireless network.
SIM limit exceeded – automatic call disconnection when the active SIM card
call limit is exceeded.
Time limit exceeded – automatic call disconnection when the active SIM card
time of use is exhausted.
No ALERTING before CONNECT – automatic call disconnection when the
gateway receives the call connect message without alerting.
Block SIM
Set the rules for SIM switching in the event of SIM limit exceeding.
– enable/disable SIM switching whenTariff 0(...4) minutes limit exceeded
the tariff 0(...4) minutes limit has been exhausted.
– enable/disable SIM switching when the SMS limit hasSMS limit exceeded
been exhausted.
– enable/disable SIM switching when the maximumMinutes limit exceeded
called minutes limit has been exhausted.
– enable/disable SIM switching when theDaily minutes limit exceeded
maximum daily minutes limit has been exhausted.
Send CLIP from VoIP/ISDN to GSM/UMTS
Transfer CLIP to GSM/UMTS – enable/disable the function.
Separating char – define the CDN/CLIP separating character.
Modify (‘–’ remove one digit) – change the CLIP. The ‘–’ character is used for
deleting one character from the left.
GPRS Activation
APN string – define the Access Point Name (APN) for GPRS connectivity.
Basic Settings
Roaming enabled for network code – set the international network identifier
for roaming purposes consisting of the following two codes:
MCC – Mobile Country Code – country code (Czech Republic – 230);
MNC – Mobile Network Code – GSM code (T-Mobile – 01, 0202, Vodafone –
03).
Hence, the international identification code for T-Mobile CZ is 23001. Leave this field
empty to disable roaming.
Caution
The Send CLIP from VoIP to GSM service must be supported by the
GSM/UMTS provider’s network. Otherwise, the call may be rejected by
GSM/UMTS!
To Next Page
Loading...
