Table of Replaced Prefixes
Use this table to replace the prefix of the received number (‘00’ with ‘+’, e.g.). You can
only add or remove the prefix. This change is made before the prefix is searched for in
the prefix table. Be sure to keep the „/“ record in the table for a proper function.
Table of Accepted Prefixes
List of prefixes of called destinations to which the selected prefix list applies.
Prefix Change for PRI 1 to PRI 2 Calls
A table of prefixes to be replaced in the case of PRI 1 to PRI 2 outgoing calls.
LCR Table
Table of outgoing Least Cost Routing (LCR) rules. Every outgoing call from the source
interface is routed to the destination interface according to this table. For a call, the
gateway checks the lines and if the called number prefix matches the prefix in the
selected network list and the current time value is within time limitation limits, the call
will be routed via the defined GSM group(s) or PRI 1/PRI 2/VoIP interface.
From (channels/groups) – source channels or groups via which calls are
routed to .2N StarGate
®
GSM ALL – any of the GSM incoming groups can be used for call routing.
GSM GRP1-32 – define one GSM incoming group or a range of GSM
incoming groups via which call routing will be enabled.
PRI1 (pxx,P) – any of the PRI1 channels can be used for call routing.
Note
The number to be dialled to the GSM/UMTS network must meet the
condition.Count of digits
For calls, the count of digits to be dialled must be equal to or higherVoIP
than the value set in the . Count of digits
For GSM/UMTS calls by overlap dialling via the interface, the PRI NT/TE
defines the maximum count of the digits to be dialled.Count of digits
For GSM/UMTS calls by block dialling via the interface, the PRI NT/TE
is ignored.Count of digits
Note
The maximum count of records in the is 14Table of replaced prefixes
for each prefix list.
The maximum table record size is 9 characters for the prefix and 9
characters for the replaced number.
Note
The maximum count of records in the is 138Table of accepted prefixes
for each prefix list.
The maximum table record size is 9 characters.
To Next Page
Loading...
