Autodial – enable/disable CLIP routing for the selected CLIP.
Reject call – reject call for the selected CLIP.
Ignore call – ignore call for the selected CLIP.
Tone dial-in – incoming GSM calls is accepted + dialtone is activated for
the selected CLIP.
DISA message dial-in – incoming GSM calls is accepted + voice
message is activated for the selected CLIP.
Dial to VoIP/ISDN – VoIP/ISDN destination number for the CLIP routing
function.
Auto CallBack – enable/disable the CallBack function for the
selected CLIP according to the Gateway configuration / GSM basic settings /
.Calls / Source interface for CallBack setting
Call duration limit – set the maximum call duration (minutes).
Ethernet Configuration
This window helps you configure the Ethernet interface of your gateway.
Use DHCP – enable/disable the DHCP client function in 2N StarGate /
®
.BlueTower
IP address – fixed IP address (v4) of the Ethernet2N StarGate / BlueTower
®
interface.
Subnet mask – subnet mask for the Ethernet2N StarGate / BlueTower
®
interface.
Default gateway – IP gateway IP address (v4) in the Ethernet network.
– primary DNS server.DNS server1
– secondary DNS server. Used as a back-up when DNS server 1 isDNS server2
not functional.
Tip
CallBack detects the CLIP from right to left. Thus, configure 10 rules for all
the incoming CLIPs to make CallBack work properly. Each of the rules
must contain one of the CLIPs: 0,1,2,3,4,5,6,7,8,9.
Note
Remember to activate the CallBack mode in the GSM incoming groups
for a proper function.
The maximum count of CLIP routing table records is 96.
Caution
Incorrect settings, e.g. enabling the , may result in aDHCP client service
denial of access to the configuration. To2N StarGate / BlueTower
®
avoid this, restore the GSM gateway default settings. Refer to Subs. Basic
for details and Jumper for default. CPU Board
Tip
In case the gateway is in the DHCP client mode, the current assignments
obtained from the DHCP server are displayed in the IP address, Subnet
and Default gateway items.mask
To Next Page
Loading...
