Messaging
This group helps:
Set the GSM gateway to send/receive SMS via SMTP/POP3 or SMPP.
Define the routing rules for incoming and outgoing SMS messages.
Check the GSM gateway SMS database filling capacity.
Modules Grouping
Global Settings
SMS server enabled – enable/disable the SMS server at the GSM gateway
(keep disabled if you select another SMS processing method).
AutoCLIP routing expires [hours] (1-10000, 0=off) – set the maximum
time for keeping of the automatic SMS routing record (response) in the AutoCLIP
table.
Not sent SMS expires in [hours] (1-10000, 0=off) – delete an SMS if unsent
within the timeout.
Received SMS expires in [hours] (1-10000, 0=off) – delete a received SMS
if undelivered to the e-mail / SMPP user within the timeout.
Delivery Report expires in [hours] (1-10000, 0=off) – delete an SMS
waiting for delivery report and make an error record in the SDR table in case no
delivery report arrives within the set period of time.
Detection of Delivery Report
Number of digits (1-20) from the right – set a count of digits to be detected
from the SMS text end in the case of positive evaluation according to Begin of
text of received SMS. The found number is compared with the addressees of the
outgoing messages.
Begin of text of received SMS – any SMS whose text beginning matches this
parameter is evaluated as a delivery report.
Caution
This service is file-licensed. Refer to for theManagement Licence key /
current GSM gateway licence details.
Caution
0=off means disabled expiry, i.e. records are saved into the AutoCLIP
routing table for an indefinite period of time. Therefore, make sure that
the routing priorities are set properly for incoming SMS. Refer to
for details.Incoming SMS routing
Note
If multiple SMS are sent to one and the same number, delivery reports
are assigned to them according to the sending time, starting from the
oldest one.
To Next Page
Loading...
