2-4
Network diagram
Figure 2-1 Network diagram for quick EAD deployment
Host
Switch
Web Server
IP network
192.168.0.110/24 192.168.0.111/24
192.168.0.109/24
GE1/0/1
Configuration procedure
Before enabling quick EAD deployment, make sure sure that:
z The Web server is configured properly.
z The default gateway of the PC is configured as the IP address of the Layer-3 virtual interface of the
VLAN to which the port that is directly connected with the PC belongs.
# Configure the URL for HTTP redirection.
<Sysname> system-view
[Sysname] dot1x url http://192.168.0.111
# Configure a free IP range.
[Sysname] dot1x free-ip 192.168.0.111 24
# Set the ACL timer to 10 minutes.
[Sysname] dot1x timer acl-timeout 10
# Enable dot1x globally.
[Sysname] dot1x
# Enable dot1x for GigabitEthernet 1/0/1.
[Sysname] dot1x interface GigabitEthernet 1/0/1
To Next Page
Loading...
