3Com 4200G 48-Port - Static Route Configuration Example; Basic Static Route Configuration Example

1-4
To do… Use the command… Remarks
Display the statistics on the
routing table
display ip routing-table statistics
Clear statistics about a
routing table
reset ip routing-table statistics
protocol { all | protocol }
Use the reset command in
user view
Delete all static routes
delete static-routes all
Use the delete command in
system view.
Static Route Configuration Example
Basic Static Route Configuration Example
Network requirements
The IP addresses and masks of the switches and hosts are shown in the following figure. Static routes
are required for interconnection between any two hosts.
Figure 1-2 Network diagram for static route configuration
Configuration procedure
1) Configuring IP addresses for interfaces (omitted)
2) Configuring static routes
# Configure a default route on Switch A.
<SwitchA> system-view
[SwitchA] ip route-static 0.0.0.0 0.0.0.0 1.1.4.2
# Configure two static routes on Switch B.
<SwitchB> system-view
[SwitchB] ip route-static 1.1.2.0 255.255.255.0 1.1.4.1
[SwitchB] ip route-static 1.1.3.0 255.255.255.0 1.1.5.6
# Configure a default route on Switch C
<SwitchC> system-view
[SwitchC] ip route-static 0.0.0.0 0.0.0.0 1.1.5.5
3) Configure the hosts.