1-12
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the information center
info-center enable
Optional
Enabled by default.
Enable system information
output to a log host
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
Required
By default, the switch does not
output information to the log
host.
After you configure the switch
to output information to the log
host, the switch uses
information channel 2 by
default.
Configure the source interface
through which log information is
sent to the log host
info-center loghost source
interface-type interface-number
Optional
By default, no source interface
is configured, and the system
automatically selects an
interface as the source
interface.
Configure the output rules of
system information
info-center source
{ modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to
Table 1-4 for the
default output rules of system
information.
Set the format of the time
stamp to be sent to the log host
info-center timestamp
loghost { date | no-year-date |
none }
Optional
By default, the time stamp
format of the information output
to the log host is date.
Be sure to set the correct IP address when using the info-center loghost command. A loopback IP
address will cause an error message prompting that this address is invalid.
Setting to Output System Information to the Trap Buffer
Follow these steps to set to output system information to the trap buffer:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the information center
info-center enable
Optional
Enabled by default.
To Next Page
Loading...
