EasyManua.ls Logo

3Com 4200G 48-Port - Qos Configuration Examples; Traffic Policing Configuration Example

3Com 4200G 48-Port
730 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-25
To do… Use the command… Remarks
Display QoS-related
configuration of a port or all the
ports
display qos-interface
{ interface-type
interface-number | unit-id } all
Available in any view
Display the priority trust mode
of a port or all the ports
display qos-interface
{ interface-type
interface-number | unit-id }
priority-trust
Available in any view
Display traffic shaping
configuration of a port or all the
ports
display qos-interface
{ interface-type
interface-number | unit-id }
traffic-shape
Available in any view
Display traffic policing
configuration of a port or all the
ports
display qos-interface
{ interface-type
interface-number | unit-id }
traffic-limit
Available in any view
Display traffic accounting
configuration of a port or all the
ports
display qos-interface
{ interface-type
interface-number | unit-id }
traffic-statistic
Available in any view
Display global QoS
configuration of traffic policing
or traffic accounting
display qos-global { all |
traffic-limit | traffic-statistic }
Available in any view
Display VLAN-level QoS
configuration of traffic policing
or traffic accounting
display qos-vlan [ vlan-id ]
{ all | traffic-limit |
traffic-statistic }
Available in any view
Display port group-level QoS
configuration of traffic policing
or traffic accounting
display qos-port-group
[ group-id ] { all | traffic-limit |
traffic-statistic }
Available in any view
QoS Configuration Examples
Traffic Policing Configuration Example
Network requirements
As shown in Figure 1-10, an enterprise network connects all the departments through a Switch 4200G.
PC1 with the IP address 192.168.0.1 belongs to the R&D department and is connected to
GigabitEthernet 1/0/1 of the switch. The marketing department is connected to GigabitEthernet 1/0/2 of
the switch.
Configure traffic policing to satisfy the following requirements:
z Set the maximum rate of outbound IP packets sourced from the marketing department to 64 kbps.
z Set the maximum rate of outbound IP packets sourced from the R&D department to 128 kbps.

Table of Contents

Related product manuals