3Com 4200G 48-Port - Page 642

1-12
To do… Use the command… Remarks
Configure the source
port
source-port port-number
Optional
By default, no source port is specified.
Configure the test type
test-type { tcpprivate |
tcppublic }
Required
By default, the test type is ICMP.
Configure the number of
probes per test
count times
Optional
By default, one probe is made per time.
Configure the automatic
test interval
frequency interval
Optional
By default, the automatic test interval is
zero seconds, indicating no automatic
test will be made.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times out in three
seconds.
Configure the maximum
number of history
records that can be
saved
history-records number
Optional
By default, the maximum number is 50.
Configure the type of
service
tos value
Optional
By default, the service type is zero.
Start the test
test-enable
Required
Display test results
display remote-ping
results [ admin-name
operation-tag ]
Required
The display command can be executed
in any view.
8) Configuring UDP test on remote-ping client
Follow these steps to configure UDP test on remote-ping client:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the
remote-ping client
function
remote-ping-agent enable
Required
By default, the remote-ping client function
is disabled.
Create a remote-ping
test group and enter
its view
remote-ping
administrator-name
operation- tag
Required
By default, no test group is configured.
Configure the
destination address
destination-ip ip-address
Required
This IP address and the one configured on
the remote-ping server for listening service
must be the same.
By default, no destination address is
configured.