3Com 4200G - Page 24

24 CHAPTER 2: INSTALLING THE SWITCH
Figure 6 Positions for mounting the screw on the switch
Follow the steps below to mount the rear bracket:
1 Use screws to fix the rear bracket to the rear mount angle.
2 Determine the position for mounting the screw on the switch
according to the position of the mount angle.
3 Mount the screw to the switch and make sure the screw and the rear
bracket are closely connected.
Figure 7 Installation completed 1
Three positions for screw mountingThree positions for screw mounting
Screw 1: Fix the rear bracket to the mount
angle.
Screw 2 is mounted to the switch.
Screw 1
Screw 2
Rear bracket
Rear mount
angle
Screw 1
Screw 2
Rear bracket
Rear mount
angle
10014914_AB_Switch 4200G.book Page 24 Tuesday, October 2, 2007 12:13 PM