3Com 4500 - Network Diagram; Configuration Procedure

1-10
Network Diagram
Figure 1-3 Network diagram for forming an XRN fabric
Configuration Procedure
1) Configure Switch A.
# Configure fabric ports.
<Sysname> system-view
[Sysname] fabric-port GigabitEthernet1/0/25 enable
# Configure the unit name as Unit 1.
[Sysname] set unit 1 name Unit1
# Configure the fabric name as hello.
[Sysname] sysname hello
# Configure the fabric authentication mode as simple and the password as welcome.
[hello] xrn-fabric authentication-mode simple welcome
2) Configure Switch B.
# Configure fabric ports.
<Sysname> system-view
[Sysname] fabric-port GigabitEthernet1/0/25 enable
[Sysname] fabric-port GigabitEthernet1/0/26 enable
# Set the unit ID to 2.
[Sysname] change unit-id 1 to 2
# Configure the unit name as Unit 2.
[Sysname] set unit 1 name unit2
# Configure the fabric name as hello.
[Sysname] sysname hello
# Configure the fabric authentication mode as simple and the password as welcome.
[hello] xrn-fabric authentication-mode simple welcome
3) Configure Switch C.
# Configure fabric ports.
<Sysname> system-view
[Sysname] fabric-port GigabitEthernet1/0/25 enable
[Sysname] fabric-port GigabitEthernet1/0/26 enable
# Set the unit ID to 3.
[Sysname] change unit-id 1 to 3