3Com 4500 - Assigning an Ethernet Port to a VLAN

2-4
Assigning an Ethernet Port to a VLAN
You can assign an Ethernet port to a VLAN in Ethernet port view or VLAN view.
z You can assign an access port to a VLAN in either Ethernet port view or VLAN view.
z You can assign a trunk port or hybrid port to a VLAN only in Ethernet port view.
1) In Ethernet port view
Follow these steps to assign an Ethernet port to one or multiple VLANs:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Access port
port access vlan vlan-id
Trunk port
port trunk permit vlan
{ vlan-id-list | all }
Assign the
current port
to one or
multiple
VLANs
Hybrid port
port hybrid vlan vlan-id-list
{ tagged | untagged }
Optional
By default, all Ethernet ports
belong to VLAN 1.
When assigning an access or hybrid port to a VLAN, make sure the VLAN already exists.
2) In VLAN view
Follow these steps to assign one or multiple access ports to a VLAN in VLAN view:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter VLAN view
vlan vlan-id
Required
If the specified VLAN does not
exist, this command creates the
VLAN first.
Assign the specified access
port or ports to the current
VLAN
port interface-list
Required
By default, all ports belong to
VLAN 1.