2-3
The operation of enabling/disabling a VLAN’s VLAN interface does not influence the physical
status of the Ethernet ports belonging to this VLAN.
Displaying VLAN Configuration
To do... Use the command... Remarks
Display the VLAN interface
information
display interface
Vlan-interface [ vlan-id ]
Display the VLAN information
display vlan [ vlan-id [ to
vlan-id ] | all | dynamic | static ]
Available in any view.
Configuring a Port-Based VLAN
Port-Based VLAN Configuration Task List
Complete these tasks to configure port-based VLAN:
Task Remarks
Configuring the Link Type of an Ethernet Port Optional
Assigning an Ethernet Port to a VLAN Required
Configuring the Default VLAN for a Port Optional
Displaying and Maintaining Port-Based VLAN Optional
Configuring the Link Type of an Ethernet Port
Follow these steps to configure the link type of an Ethernet port:
To do… Use the command… Remarks
Enter system view
system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the port link type
port link-type { access |
hybrid | trunk }
Required
The link type of an Ethernet
port is access by default.
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
first.
To Next Page
Loading...
