3Com 4500 - Managing a Cluster through the Management Device

1-16
To do… Use the command… Remarks
Enter Ethernet port view
interface interface-type
interface-number
—
Enable NTDP on the port
ntdp enable
Required
Enabling the cluster function
Follow these steps to enable the cluster function:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the cluster function
globally
cluster enable
Optional
By default, the cluster function
is enabled.
Accessing the shared FTP/TFTP server from a member device
Follow these steps to access the shared FTP/TFTP server from a member device:
To do… Use the command… Remarks
Access the shared FTP server
of the cluster
ftp cluster
Optional
Available in user view
Download a file from the shared
TFTP server of the cluster
tftp cluster get source-file
[ destination-file ]
Optional
Available in user view
Upload a file to the shared
TFTP server of the cluster
tftp cluster put source-file
[ destination-file ]
Optional
Available in user view
Managing a Cluster through the Management Device
You can manage the member devices through the management device, for example, adding/removing
a cluster member, rebooting a member device, logging into a member device, and so on.
Follow these steps to manage a cluster through management device:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Add a candidate device to the
cluster
add-member
[ member-number ]
mac-address H-H-H
[ password password ]
Optional
Remove a member device from
the cluster
delete-member
member-number
Optional
Reboot a specified member
device
reboot member
{ member-number |
mac-address H-H-H }
[ eraseflash ]
Optional