1-13
2) Establish a cluster in automatic mode
Follow these steps to establish a cluster in automatic mode:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Configure the IP address range
for the cluster
ip-pool
administrator-ip-address
{ ip-mask | ip-mask-length }
Required
Start automatic cluster
establishment
auto-build [ recover ]
Required
Follow prompts to establish a
cluster.
z After a cluster is established automatically, ACL 3998 and ACL 3999 will be generated
automatically.
z After a cluster is established automatically, ACL 3998 and ACL 3999 can neither be modified nor
removed.
Configuring inside-outside interaction for a cluster
Follow these steps to configure inside-outside interaction for a cluster:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
Required
Configure a shared FTP server
for the cluster
ftp-server ip-address
Optional
By default, the management
device acts as the shared FTP
server.
Configure a shared TFTP
server for the cluster
tftp-server ip-address
Optional
By default, no shared TFTP
server is configured.
Configure a shared logging
host for the cluster
logging-host ip-address
Optional
By default, no shared logging
host is configured.
Configure a shared SNMP host
for the cluster
snmp-host ip-address
Optional
By default, no shared SNMP
host is configured.
Configuring the network management interface for a cluster
1) Configuration prerequisites
To Next Page
Loading...
