3Com 4500 - Page 496

1-20
z NDP and NTDP have been enabled on the management device and member devices, and NDP-
and NTDP-related parameters have been configured.
z A cluster is established, and you can manage the member devices through the management
device.
2) Configuration procedure
Perform the following operations on the management device to synchronize SNMP configurations:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
—
Create a public SNMP
community for the cluster
cluster-snmp-agent
community { read | write }
community-name [ mib-view
view-name ]
Required
Not configured by default.
Create a public SNMPv3 group
for the cluster
cluster-snmp-agent group v3
group-name [ authentication |
privacy ] [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ]
Required
Not configured by default.
Add a public SNMPv3 user to
the group
cluster-snmp-agent
usm-user v3 username
groupname
[ authentication-mode { md5 |
sha } authpassstring
[ privacy-mode { des56
privpassstring } ] ]
Required
Not configured by default.
Create or update the public MIB
view information for the cluster
cluster-snmp-agent mib-view
included view-name oid-tree
Required
Not configured by default.
z Perform the above operations on the management device of the cluster.
z Configuring the public SNMP information is equal to executing these configurations on both the
management device and the member devices (refer to the SNMP-RMON Operation part in this
manual), and these configurations will be saved to the configuration files of the management
device and the member devices.
z The public SNMP configurations cannot be synchronized to the devices that are on the cluster
blacklist.
z If a member device leaves the cluster, the public SNMP configurations will not be removed.
3) Configuration example
# Configure the public SNMP information for the cluster on the management device, including the
following:
z The read community name is read_a
z The write community name is write_a
z The group name is group_a