1-3
Table 1-2 Display remote-ping configuration
Operation Command Description
Display the information of
remote-ping test history
display remote-ping history
[ administrator-name
operation-tag ]
Display the latest remote-ping
test results
display remote-ping results
[ administrator-name
operation-tag ]
The display command can be
executed in any view.
Configuration Example
Network requirement
Perform an remote-ping ICMP test between two switches. Like a ping test, this test uses ICMP to test
the RTTs of data packets between the source and the destination.
Configuration procedure
# Enable remote-ping Client.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] remote-ping-agent enable
# Create an remote-ping test group “administrator icmp”.
[Sysname] remote-ping administrator icmp
# Specify the test type as ICMP.
[Sysname-remote-ping-administrator-icmp] test-type icmp
# Specify the destination IP address as 1.1.1.99.
[Sysname-remote-ping-administrator-icmp] destination-ip 1.1.1.99
# Set the number of test packets sent in a test to 10.
[Sysname-remote-ping-administrator-icmp] count 10
# Set the timeout time of test operations to 5.
[Sysname-remote-ping-administrator-icmp] timeout 5
# Enable the test operation.
[Sysname-remote-ping-administrator-icmp] test-enable
# Display the test results.
[Sysname-remote-ping-administrator-icmp] display remote-ping results administrator icmp
remote-ping entry(admin administrator, tag icmp) test result:
Destination ip address:1.1.1.99
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 2/5/2
Square-Sum of Round Trip Time: 66
Last complete test time: 2000-4-2 7:59:54.7
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
To Next Page
Loading...
