Methods of Managing a Switch 39
Command Line
Interface
Management using
SSH
The Switch 4500 supports Secure Shell version 2.0 (SSHv2.0), allowing
secure access to the Command Line Interface of the Switch.
If you use SSH to administer your Switch and the network traffic is
intercepted, no passwords or configuration information will be visible in
the data. To securely administer the Switch using the Command Line
Interface you need a third party SSH client.
Web Interface
Management
Each Switch has an internal set of web pages that allow you to manage
the Switch using a Web browser remotely over an IP network (see
Figure 12).
Figure 12 Web Interface Management over the Network
Refer to “Setting Up Web Interface Management” on page 54.
SNMP Management You can manage a Switch using any network management workstation
running the Simple Network Management Protocol (SNMP) as shown in
Figure 13. For example, you can use the 3Com Network Director
software, available from the 3Com website.
Figure 13 SNMP Management over the Network
Refer to “Setting Up SNMP Management V1 or V2” on page 55.
Workstation
Switch
Connect over Network
via web browser
SNMP Network Management
Workstation
Switch
Connect over Network
using SNMP
To Next Page
Loading...
Need help?
General