Methods of Managing a Switch 49
The initial set up of your Switch is now complete and the Switch is ready
for you to set up your chosen management method. See “Methods of
Managing a Switch” on page 49.
If you do not intend to use the command line interface via the console
port to manage the Switch, you can logout, disconnect the serial cable
and close the terminal emulator software.
Methods of
Managing a Switch
Once you have completed the initial set up of your Switch, you can
decide how you wish to manage the Switch. You can use one of the
following methods:
■ Command line interface management
■ Web interface management
■ SNMP management
Command Line
Interface
Management
Each Switch has a command line interface (CLI) that allows you to
manage the Switch from a workstation, either locally via a console port
connection (see Figure 18
), or remotely over the network (see Figure 19).
Figure 18 CLI management via the console port
Figure 19 CLI management over the network
Refer to “Setting Up Command Line Interface Management” on
page 50
.
DUA1720-3AAA05.book Page 49 Friday, March 7, 2003 11:53 AM
To Next Page
Loading...
