About the Switch 4200 Series 17
Default Settings Table 5 shows the default settings for the Switch 4200 Family:
Table 5 Default Settings
If you initialize a Switch unit by selecting System > Control > Initialize in
the Web interface or by entering system control initialize
in
the Command Line Interface, the following settings are retained to allow
you to connect to and manage the Switch:
■ IP Address
■ Subnet Mask
■ Default Router
Feature Switch 4200 Family
Automatic IP Configuration Enabled
Port Status Enabled
Port Speed All ports are auto-negotiated, except SFP ports
Duplex Mode All ports are auto-negotiated, except SFP ports
Flow Control ■ Enabled in half duplex
■ Auto-negotiated in full duplex
Broadcast Storm Control Enabled
Virtual LANs (VLANs) All ports belong to the untagged Default VLAN
(VLAN
1) with IEEE802.1Q learning operational
IP Multicast Filtering Filtering enabled
Rapid Spanning Tree Protocol
Fast Start
Enabled
Enabled on all 10/100 Mbps ports
Disabled on all 1000 Mbps ports
RMON Alarm Enabled
Smart Auto-Sensing Enabled
LACP (10/100/1000BASE-T ports and SFP ports only)
Disabled
Quality of Service (QoS) All ports prioritize NBX VoIP IP.
All ports set to “best effort” for all other traffic.
HOL Protection (QoS) 18 Kb
DUA1730-0AAA03.book Page 17 Thursday, November 17, 2005 12:17 PM
To Next Page
Loading...
Need help?
General
