3Com Switch 4210 Series User Manual

Configuring the Boot Loader Using the Boot Menu 69
Upgrading the Boot
ROM from the Boot
Menu using XModem
To upgrade the Boot ROM firmware from the Boot menu using XModem do the
following:
1 From the Boot Menu, select option 6 to display the following:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
2 Select option 3 to display the following:
Please select your download baudrate:
1. 9600
2.*19200
3. 38400
4. 57600
5. 115200
0. Return
Enter your choice(0-5):
3 Select option 2 to set the baudrate to 19200.
You will also need to change the baudrate on Hyperterminal to 19200 bps and
select XModem protocol.
4 Press Enter to start the download. The following information is displayed:
Now please start transfer file with XMODEM protocol
If you want to exit, Press <Ctrl+X>
Loading
...CCCCCCCCCCCCCCCCCCCCCCCCCCCCC
5 As the file downloads, start the XModem send file process with terminal
emulation software, such as Microsoft Hyperterminal.
When the download is complete, the following information is displayed:
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCdone!
Bootrom updating.........done!

3Com Switch 4210 Series Specifications

General

Model	3Com Switch 4210 Series
Layer	Layer 2
Management	CLI
VLAN Support	Yes
QoS	Yes
Jumbo Frame Support	Yes
Power Supply	Internal
Operating Temperature	0°C to 40°C
Relative Humidity	10% to 90% non-condensing
Uplink Ports	4 SFP ports (on 24-port model), 4 SFP ports (on 48-port model)
Dimensions (W x D x H)	440 x 260 x 44 mm (24-port model), 440 x 260 x 44 mm (48-port model)