Wall Mounting the Wireless 7760
11
Power up
Self test (POST)
At power up, the product will carry out a self-test (POST). POST will
run a test on the wireless circuit to check it is functioning correctly.
When running the POST test, 11a and 11b/g’s LEDs will flash
alternatively.
When firmware is corrupted, 11a and 11b/g’s LEDs will flash
alternatively also.
Attaching an External
Antenna
This AP comes with two antennas. They are external removable
monopole dual-band 2.4 GHz/5 GHz antennas. They can be rotated
over 360 degrees and are omni-directional with a gain of less than
2 dBi. The RF connector is an R-SMA type.
If you require a different type of antenna for the Access Point
7760, several options are available from the 3Com
(www.3Com.com).
To Next Page
Loading...
