Service
33
Service
Management VLAN If you reconfigure the Management VLAN ID, you may lose
connectivity to the access point. Verify that the switch and DHCP
server can support the reconfigured VLAN ID, and then re-connect
to the new IP address.
IAPP Inter-Access Point Protocol (IAPP)
802.11F (IAPP) Support - Choose either Enable or Disable
IAPP allows multiple access points to communicate and pass
location information about their associated stations. If you enable
802.11F support you should manually add BSSID/IP mapping:
Enter the BSSID and IP addresses of the AP. Click Add
Only stations roaming from one of the listed APs to this AP ar
through the full association process.
QoS
This section provides the administrator with the Quality of Service
(QoS) data.
To Next Page
Loading...
