Remote Wake-up 1-3
Remote Wake-up
Remote Wake-Up support is enabled for the 3C905B-TX NIC.
If you are using the 3C905B-TX NIC in a PC that supports
Remote Wake-Up through the PCI bus, the 3Com NIC
receives wake-up signals and wakes the PC from a sleep state.
Installation and Configuration
The 3Com NIC Diagnostics program allows you to test
the 3C905B-TX NIC, configure it, and display the NIC
configuration information. If you are running DOS, you
cannot use this program.
The NIC Diagnostics Help system includes the 3C905B-TX
Release Notes, Frequently Asked Questions, and
KnowledgeBase.
Microsoft Windows 95
detects the 3C905B-TX NIC and
installs the network driver from 3Com EtherDisk Diskette #2.
The AutoLink
™
installation software automatically installs
all Novell
NetWare
DOS ODI client software into your
operating system.
10/100 Mbps Support
The single RJ-45 connector on the network cable supports
10 Mbps or 100 Mbps speeds.
NWay auto-negotiation enables the 3C905B-TX NIC to
automatically run at the speed that the connected hub
supports. The 3C905B-TX NIC works with products that
comply with IEEE 10BASE-T and 100BASE-TX specifications.
PC and Server Requirements
Your PC or server must have:
■ An 80386, 80486, Pentium, or Alpha processor
Alpha processors or drivers work only with
Windows NT 4.0
■ An available bus mastering PCI slot
■ A minimum of 640K of memory
Book Page 3 Thursday, April 2, 1998 9:28 AM
To Next Page
Loading...
