5
CHANGING CONFIGURATION
This chapter describes how to display and change
configuration settings for the 3C905B-TX NIC using the
3Com NIC Diagnostics program.
Before you change the settings, contact your system
administrator.
Configuration Settings
Table 5-1 lists each configuration option, the default
setting, and the available settings.
.
CAUTION: Before setting the 3C905B-TX NIC for full-duplex,
make sure that the switch port is also set to full-duplex or
supports full-duplex and auto-negotiation (NWay).
Full-duplex at 100 Mbps improves the performance of
switch (hub) connections. The 3C905B-TX NIC supports
full-duplex at 10 or 100 Mbps. If the switch supports the
NWay feature and full-duplex, the 3C905B-TX NIC
automatically runs in full-duplex.
Table 5-1 Option Settings
Option Default Setting Available Settings
Network Driver
Optimization
Normal Minimize CPU Utilization, Maximize
Network Performance, Normal
Full-Duplex Auto Select Enabled, Disabled, Auto Select
Boot PROM Disabled Disabled, 8K, 16K, 32K
Media Type Auto Select 100BASE-TX, 10BASE-T, Auto Select
PACE Disabled Enabled, Disabled
NDIS Driver Speed None 100 Mbps, 10 Mbps (Windows NT only),
N/A (Windows 95)
Remote Wake-Up No Yes, No
Book Page 1 Thursday, April 2, 1998 9:28 AM
To Next Page
Loading...
