3-6 CHAPTER 3: INSTALLING THE NETWORK DRIVER
3 In the Control Panel, double-click Network.
4 In the Network window, select the Adapter tab.
5 Select 3Com EtherLink XL NIC.
6 Click Update.
7 Insert EtherDisk Diskette #2.
The driver is updated.
Installing the Network Driver
Follow these steps to install the network driver in a PC
running Windows NT version 4.0:
1 Install the 3C905B-TX NIC and connect it to the
network, as described in Chapter 2.
2 Restart the PC and start Windows NT.
3 In the Control Panel, double-click Network.
4 In the Network window, select the Adapter tab.
If this 3C905B-TX NIC is replacing a NIC already installed,
follow these steps:
a Select the existing 3Com NIC (that is being replaced) in
the Installed Adapters group.
b Click Remove.
c Click Yes in the Warning dialog box.
d Reboot the PC and repeat steps 2, 3, and 4.
5 Click Add Adapter.
6 In the Select Network Adapter window, select
Have Disk.
7 Insert EtherDisk Diskette #2 in drive A and in the
Insert Disk window, click OK.
8 In the Select OEM Option box, select 3Com EtherLink
Adapter (3C905B).
9 Click OK.
10 Select the Protocol tab.
11 Select the appropriate protocol for your network.
Book Page 6 Thursday, April 2, 1998 9:28 AM
To Next Page
Loading...
