Need help?Do you have a question about the 3DP Workbench and is the answer not in the manual?
General| Heated Bed | Yes |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Supported Materials | PLA, ABS, PETG, TPU |
| Connectivity | USB |
Controls operation and stores print files.
Main power switch and PC interface.
Includes serial number location, electrical panel, emergency stops.
Lists safety features like bumpers, wire covers, and E-stops.
General safety advice for operation and maintenance.
Precautions during printer operation.
Instructions for installing the printer driver.
Guidance on installing recommended 3D printing software.
Safety advice and optimal environment for printer operation.
Procedure to align actuators before powering up.
Guide for connecting wiring and setting up components.
Checking the functionality of emergency stop buttons.
Steps to safely power on the printer.
Steps to power on the printer using the control unit.
How to check the functionality of position sensors.
Connecting the printer to a PC via USB and software.
Guide for loading filament into the extruder.
How to change filament during or after printing.
Explains the functions of the LCD control unit.
Guides for loading and changing filament.
How to print directly from SD card or via USB.
Details the operation and reset of E-stop buttons.
Safety precautions for maintenance tasks.
Steps for cleaning the nozzle using the cold-pull method.
Step-by-step guide to replacing the nozzle.
Instructions to verify bed level using a test file.
Importance and adjustment of Z-gap for first layer.
Using babystepping to adjust Z-gap during printing.
Qualities and tips for a successful first layer.
Common questions about open source, materials, and print quality.
Provides contact details for technical assistance.
Resources for technical questions and support.
To Next Page
