3M Touch Systems Proprietary Information
21
Mounting
Panel gasket mount
The NEMA 4X Panel Gasket Kit ships with the terminal. When properly installed
between the bezel and a wall or panel and when the installation instructions are
followed, the panel gasket provides a NEMA 4X/IP66 seal around the front of the
terminal.
The terminal is suitable for Pollution Degree 3 environments if installed and tested
with the panel gasket in an enclosure that meets NEMA 4X/IP66 ratings. If the
terminal is not mounted in such an enclosure or if it is mounted without the gasket,
the terminal is suitable for Pollution Degree 2 environments.
Figure 9: Side view: NEMA panel gasket mount
Optional mounting methods
There are four optional mounting kits available from 3M Touch Systems that
allow the terminal to be installed with:
! NEMA 4X hatch (or NEMA 4X extended hatch)
! Rack mount (for mounting in a standard 19-inch equipment rack)
! Boom (or pole)
! Desktop stand
An overview of each optional mounting method appears below. Installation
instructions accompany each of the optional mounting kits and should be read and
understood before mounting the terminal. Instructions for each mounting kit are
available for download at www.3Mtouch.com
.
Important
The information in this section offers only an overview of the panel gasket mounting
method. Before installing the panel gasket, refer to the installation instructions that come
with the kit.
To Next Page
Loading...