3M Dynapro ET 3170 Terminal Series B - Figure 16: Setup Screen; Table E: Touch Key Functions: Direct Action Area

3M Touch Systems Proprietary Information
27
Configuring
Each touch key in the Display Action Area identifies a keyboard key or key
combination so that you can use either the touch screen or an optional
keyboard. The function of each touch key is shown in Table E.
Figure 16: Setup screen
Table E: Touch key functions: Direct Action Area
Touch key
(keyboard equivalent)
Function
RESET
(Shift/Set Up)
n Executes a soft reset.
n Resets all Setup parameters to their last saved values,
sounds the beeper, and initiates automatic power-up self-
testing. (A hard reset, accessible only by remote
command from the host, resets the terminal to its factory-
programmed default state.)
TEST
(Shift/T)
n Calls up the test screen that provides touch panel
operation of user-selectable tests
SAVE
(Shift/S)
n Executes a Save Setup command.
n The Save Setup command loads into nonvolatile setup
memory all the parameter values as they are programmed
in the current session
RECALL
(Shift/R)
n Executes a Recall Setup command.
n The Recall Setup command overwrites all the parameter
values programmed in the current Setup session with the
values previously saved in nonvolatile Setup memory with
a Save Setup command.