EasyManua.ls Logo

3M Dynapro ET 3170 Terminal Series B - Extended Character Set Test; Keyboard Test; Standard Character Set Test

3M Dynapro ET 3170 Terminal Series B
125 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3M Touch Systems Proprietary Information
43
Configuring
Standard Character Set Test
The Standard Character Set Test provides a detailed view of the contents of the
Standard Character Set. To begin the test, touch the STANDARD
CHARACTERS touch key on the Test screen, or press Shift/4 on the optional
keyboard. The characters in the Standard Character Set (including those
underlying control codes) are displayed in double size. The characters on the
screen are arranged in a checkerboard pattern for easy recognition.
Unless changed by the host application program, the Standard Character Set uses
the Static ASCII Character Font, which can be viewed in detail by running the
Static ASCII Character Font Test. See “Static ASCII Character Font Test” on
page 47.
The test remains active until you press the Setup key on the keyboard or touch the
Setup switch. This returns the terminal to the Test screen.
Extended Character Set Test
The Extended Character Set Test provides a detailed view of the contents of the
Extended Character Set. To begin the test, touch the EXTENDED
CHARACTERS on the Test screen, or type Shift/5 on the optional keyboard.
Each character in the Extended Character Set is displayed in double size,
including characters that underlie control codes. The characters on the screen are
arranged in a checkerboard pattern for easy recognition. Unless changed by the
host application program, the Extended Character Set uses the Static Special
Character Font, which can be viewed in detail by running the Static Special
Character Font Test. See “Static Special Character Font Test” on page 47.
The test remains active until you press the Setup key on the keyboard or touch the
Setup switch. This returns the terminal to the Test screen.
Keyboard Test
You can verify correct operation of all keys on the optional keyboard with the
Keyboard Test. To begin the test, touch the KEYBOARD touch key on the Test
screen, or press Shift/6 on the keyboard. This calls up a picture of the keyboard
(without the setup key) on the display. The outline of each key is initially lit in
normal video (Figure 20).
Important
The current Keyboard Test is set up to map an older keyboard than you may be using
currently. Not all key presses will correspond to what is on your keyboard.

Table of Contents