30
If the selected type of utility marker is detected, a second audio tone will
emit from the unit and the marker bar graph will fill. The marker utility will
default to the last type of marker set in marker locate mode.
To change the type of marker that the unit will detect in alert mode,
Press Locate [5] + Marker [SK] + Marker 1 [SK Toggle].
Single Marker Locate
Press Locate [5]
Press Marker [SK]
Press Markr 1 [SK Toggle] to select desired utility.
Markr 2 should be OFF.
Note: Only the marker types enabled in the setup menu will be shown.
(See Enabling/Disabling Marker types). When scanning for markers, the
gain level [12] should be set high.
When a marker is detected, adjust the Gain Down [4] until the bar graph
opens.
The bar graph will close, the audio will be steady, and the signal strength
will be maximum when the receiver detects a marker of the specified utility.
To Next Page
Loading...
Need help?
General
