3M G5 - Power up

Installation
March 2014 – Revision 2.0
Page 34 of 74
3M™ Drive-Thru Systems Model G5 and Model XT-1
Installation Manual
Power Up
After installation is complete, you can power up the system by plugging in the
base station transformer.
Run Mode Menu
When the system is powered up and functioning normally, the Run mode menu
appears on the display. Figure 17 shows the Run mode menu.
Figure 17
Navigating in the Base Station in Run Mode
To navigate the base station in Run mode you only need to use
Enter, Mode, and
the directional arrow buttons: up , down , left , and right . The
remaining buttons function only in manager or installer configuration modes.
13:25 WED,NOV/16/2005
|
MODE< ML/PTT >
NOISE REDUCTION [LOW]
|
LANE 2 <SPLIT>
GREETER PLAYING MSG 1
|
VOLUME < DAY >