Installation
March 2014 – Revision 2.0
Page 30 of 74
3M™ Drive-Thru Systems Model G5 and Model XT-1
Installation Manual
Note:
The diagram assumes you are using Vehicle Detector 2 (VEHDET.2) for your
vehicle approach detector. You can also use Vehicle Detector 3
(VEHDEH.3). To do so, use the corresponding RELAY3_COM and
RELAY3_NO terminals.
Figure 13
Installing Accessory Boards in the Base Station
Accessory boards include up to three vehicle detectors, greeter module and timer
module. They must be installed into the base station according to the following
procedures.
Vehicle approach detector (board
or loop) connected at VEH
DET.2 terminals
Connect VEH_APP to RELAY2_NO
and connect GND to RELAY2_COM
To Next Page
Loading...
