3M G5 - Change the Monitor Volume

Configuration
March 2014 – Revision 2.0
Page 40 of 74
3M™ Drive-Thru Systems Model G5 and Model XT-1
Installation Manual
Change the Monitor Volume
The monitor is an additional speaker that can be used to monitor drive thru
communication without a headset, typically in the kitchen. If the monitor has a
volume control built into it, you can use it to control the overall volume level of
the speaker. To be more specific about which elements you want to control,
follow the instructions in the following sections.
Inbound Listen
Changing the inbound listen volume affects how loudly the monitor plays the
inbound (customer order point) communication. You can also disable the
monitor playing inbound sounds.
To change the inbound listen monitoring settings:
• Enter the configuration mode, see page 35.
• Select 02 Monitor Volume.
• To enable or disable the monitor playing the inbound sounds, change
the value for Inbound Listen: Enable to ON or OFF.
• To change the volume level, select a new value for Inbound Listen:
Volume. The range is 0 (silent) to 20 (maximum).
Outbound Talk
Changing the outbound talk volume affects how loudly the monitor plays the
outbound (order taker) communication. You can also disable the monitor
playing outbound talk.
Note:
To avoid feedback and echo, set the outbound talk volume as low as possible.
To change the outbound talk monitoring settings:
• Enter the configuration mode, see page 35.
• Select 02 Monitor Volume.
• To enable or disable the monitor playing the outbound talk, change the
value for Outbound Talk: Enable to ON or OFF.
• To change the volume level, select a new value for Outbound Talk:
Volume. The range is 0 (silent) to 20 (maximum).
Vehicle Present
Changing the vehicle present volume affects how loudly the monitor plays the
vehicle present tone. You can also disable the monitor playing the vehicle
present tone.
To change the vehicle present monitoring settings:
• Enter the configuration mode, see page 35.
• Select 02 Monitor Volume.
• To enable or disable the monitor playing the vehicle present tone,
change the value for Vehicle Present: Enable to ON or OFF.
• To change the volume level, select a new value for Vehicle
Present: Volume. The range is 0 (silent) to 20 (maximum).