3M G5 - Change Site Scheduling

Configuration
March 2014 – Revision 2.0
Page 50 of 74
3M™ Drive-Thru Systems Model G5 and Model XT-1
Installation Manual
• Auto Listen/Manual Latching Talk
• Hands Free
• Outside
• Always On (Bypass Vehicle Detector)
(Press  or  to scroll up and down the list)
Notes:
Order taking modes are described in the Operation section.
3M recommends you do not set up more than three order taking modes.
Change Site Scheduling
The site schedule is the calendar of store open and closing times.
Note:
All timekeeping is done using a 24 hour clock (e.g., 6:00 p.m. appears as
18:00).
Regular Site Schedule
The regular site schedule is the opening and closing times for each day of the
week and the times assigned as “Day” and “Night,” which determine when the
day and night volume settings change.
Perform the following procedure to set the regular site schedule:
• Enter the base station configuration mode, see page 35.
• Navigate to 10 Site Scheduling > Regular Site Schedule.
• Change the value for each day of the week and each of the four defined
fields (Open, Day, Night, and Close).
(Press , , , and  to scroll up and down the list).
Note:
The greeter will not play messages while the store is closed, except for the
(built-in or custom) store closed message.
Holiday/Exception Schedule
The holiday/exception schedule can be used to identify up to 12 days in the year
on which the store schedule is different than it would have been otherwise. The
holiday/exception schedule should be updated at least once a year to ensure it
conforms to the current year’s calendar.
Perform the following procedure to set the holiday/exception schedule:
• Enter the base station configuration mode, see page 35.
• Navigate to 10 Site Scheduling.> Holiday/Exception
Schedule.
• For each day that needs a non-typical schedule, enter the three-letter
month and two digit date under Date, then change the open and close
times on the line to the right of the date.
(Press , , , and  to scroll through the fields.)