68
maximum tolerable amount of radiation and must be
replaced.
^
The 3M™ Peltor™ Uvicator and the helmet must be
equally exposed to light. The 3M™ Peltor™ Uvicator
disc must not be covered by stickers or removed from
the helmet.
APPROVALS
These products meet the requirements of the European
Community Directive 89/686/EEC (Personal Protective
Equipment Directive) and are thus CE marked.
Certi¿cation under Article 10, EC Type-Examination and
Article 11, EC Quality Control, has been issued by the
Swedish National Testing and Research Institute, SP,
Box 857, SE-501 15 Boras, Sweden (Noti¿ed Body
number 0402).
CLEANING INSTRUCTIONS
The helmet, head harness and sweatband should be
cleaned regularly using a mild solution of detergent in
warm water.
Material: UV-Stabilised ABS
STORAGE AND TRANSPORTATION
^
Do not store the safety helmet in direct sunlight or at
high temperatures.
When not in use, it should be stored in a cool, dark
location to prevent the material from ageing. The
original packaging is suitable for transporting the
product.
SPARE PARTS
Standard Suspension (Figure 3)
G2C - Plastic Sweatband (HYG3)
G2D - Leather Sweatband (HYG4)
Ratchet Suspension (Figure 4)
G2N - Plastic Sweatband (HYG3)
G2M - Leather Sweatband (HYG4)
ACCESSORIES
Rain Shield (Figure 5)
Orange GR3C
Orange/Fur GR3D
Yellow GR3C GU
Hearing Protectors (Figure 6)
See appropriate product user instruction
Visors and Mesh Visors (Figure 7)
Chinstrap GH1 (Figure 8)
Chinstrap GH4 (Figure 9)
Attachment for Visor P3E (Figure 10)
Visor Seal (Figure 11)
Orange GR2B
Yellow GR2B GU
COMPREHENSIVE HEAD PROTECTION
When you use other protective equipment together with
your helmet, it is important that all the components
included in the helmet system ¿t together without
compromising the special comfort and convenience
requirements applied to each individual component in
the system.
It is vital that there is suf¿cient space for the hearing
protector and that it can be conveniently adjusted to ¿t
the ears. In other words, the helmet itself should not
extend too far down or there should be cutouts to
accomodate the hearing protectors. The combination of
helmet and visor must also function properly as regards
the distance to the face, focus of vision, sealing etc.
Your 3M™ Peltor™ helmet can be supplemented with
other 3M™ Peltor™ equipment such as hearing
protectors, visors and communication systems. Only
approved hearing protectors which meet the
requirements of EN 352-3 may be used with this helmet.
To Next Page
Loading...
