3M SE-402 - Meter Settings; Setting up Meter Parameters; Figure 3-3: Choosing Meter Settings; Figure 3-4: Choosing Meter Settings

Setup/instrument configuration
Meter settings
Sound Examiner SE-400 Series
10
Meter settings
The Meter Settings screen is used to select general instrument parameters including the log interval,
exchange rate, language, contrast, and peak weighting. Table 3-1 outlines the meter/general settings on the
SE-400 Series.
 Setting up meter parameters
1. From the setup screen, press / keys to select Settings and press key.
Figure 3-3: Choosing meter settings
2. To select one of the meter settings, press / keys. Once selected, press key.
• This moves the selection to the changeable /value field.)
3. To change the log rate, exchange rate, peak weighting, language, and/or contrast, press /
keys. Press key to save the selection. Repeat as necessary or escape to abort.
Figure 3-4: Choosing meter settings
Shading denotes the setting/parameter is
selected (e.g., Log interval)
Settings (selected)
Exchange Rate setting (3, 4, or 5 dB)