To Next PageTo Next Page
Need help?Do you have a question about the 3M Stormscope Series 2 and is the answer not in the manual?
General| Brand | 3M |
|---|---|
| Model | Stormscope Series 2 |
| Category | Measuring Instruments |
| Language | English |
Details the carrying case containing the keyboard, display, battery, and electronics.
Describes the transmitting antenna used for coupling test signals to the Stormscope system.
Explains the 25-foot cable connecting the WX-PA to the test antenna.
Describes the adaptor allowing WX-PA to drive Series II systems without an antenna.
Details the test plug used for output verification and checking operational integrity.
Describes the 12V lead-acid battery charger for portable operation.
Explains the Liquid Crystal Display, its lines, and character capacity.
Describes the control panel components: keyboard, VIEW control, and jacks.
Details the Continuous Output Mode for generating a series of test signals.
Explains the Single Shot Output Mode, outputting one test signal per ENTR press.
Describes the Circular Pattern mode for test signals at selected range and incremented bearing.
Details the Storm Simulator Mode for demonstration and testing of system capabilities.
Explains functions like Mic Key Inhibit and Heading Stabilization.
Details the Mic Key Inhibit function, activated by pressing "I".
Explains functions related to heading stabilization for Series II systems.
Outlines the requirement for a bench test prior to installation using a connector pod.
Details the Output Verify mode and its associated waveform tests.
Lists expected oscilloscope waveform characteristics for various test points.
Explains how to handle "COMM ERROR" or out-of-tolerance waveforms and return for service.
Explains the typewriter-like interface for entering checklist information.
Describes the blinking block cursor and its movement.
Details how arrow keys control cursor movement within the editor.
Explains typeover and insert modes for character entry.
Explains the use of the 2ND key for symbols, functions, and word entry.
Details how to capitalize characters and enable CAPS LOCK.
Describes entering pre-defined words using the 2ND key.
Explains how to select or edit checklist titles from the menu.
Describes the interface and initial steps for editing a checklist title.
Explains the F2 key function for deleting characters.
Details how to exit title editing and return to the Checklist Menu.
Explains how to save the entered or modified checklist title.
Describes entering and editing individual items within a checklist.
Explains the F2 key function for deleting characters in item editing.
Details how F3 inserts a blank line for new checklist items.
Explains the F4 key function for deleting an entire checklist item line.
Describes exiting item editing and returning to the Checklist Menu.
Explains how to save an entered checklist item.
Details the initial setup and connections for testing installed units.
Explains how to check azimuth accuracy using the WX-PA in Continuous Output Mode.
Details how to check range accuracy using Circular Pattern Mode.
Provides a procedure to bypass the Series II system antenna for troubleshooting.
Explains the function of the lid switch and its effect on battery power.
Describes the automatic power down feature to conserve battery life.
Details the low battery shutoff mechanism and service return procedure.
Explains the automatic charger shutoff feature to prevent over-charging.
Lists the physical dimensions and weight of the WX-PA enclosure.
Lists the physical dimensions and weight of the WX-PA antenna.
Specifies the rating of the WX-PA battery charger.
