3M Stormscope Series 2 User Manual

S~rmscope
Senes II Weather Mapping Systems
WX-PA Instruction Manual
Cont...inuous Out...
Range = 30nl"l
Ranget
Ser'ies I I
Bearing -
P~USED
Range.J.. Bearingt Bear i rlg.J..
Continuous Output Mode
Figure 4.2
In a similar manner, the bearing of the test signal may be varied by use of the F3 and F4
keys. Each press of F3 increases the bearing by 30 degrees, while F4 decreases the bearing
by 30 degrees.
The range and bearing may be changed either before starting the test signal output, or while
the test signal is being output.
4.2. Single Shot Output
The Single Shot Output mode is similar to the Continuous Output mode, except that only a
single test signal is output for each press of the
ENTR key.
The range and bearing of the test signal is varied just as in the Continuous Output mode.
The Series Number, and Top Mount or Bottom Mount are selected as in the Continuous
Output Mode, Section 4.1 paragraph 1.
Page 1-10
SEPT 88

3M Stormscope Series 2 Specifications

General

Brand	3M
Model	Stormscope Series 2
Category	Measuring Instruments
Language	English