3M Versaflo TR-800 User Manual

Below is a summary of steps to follow each time a 3M™ Versaflo™ TR-800 Powered Air Purifying Respirator (PAPR) is worn.
1. Push ‘Test’ button to confirm
battery charge – 5 bars =
80-100%.
2. Attach battery pack to
motor/blower. Gently tug bat-
tery pack to confirm a secure
connection.
3. Attach filter/cartridge (with filter
cover), and belt to motor/blower.
Gently tug filter/cartridge to confirm
a secure connection.
4. Turn on PAPR. Confirm LEDs
flash on startup. Confirm audible
alarm sounds.
5. Confirm airflow is sufficient.
Bottom of the ball above airflow
indicator zone flow level.
6. Align pins and insert breathing
tube into PAPR air outlet, turn
connector 1/4 turn clockwise.
Confirm connection by tugging
lightly on connection next to
outlet.
7. Inspect headtop for damage.
Connect breathing tube to headtop.
8. Don PAPR per workplace
procedures.
WARNING
!
This product is part of a system that helps reduce exposures to certain airborne contaminants. Before use, the wearer must read
and understand the User Instructions. Follow all local regulations. In the U.S., a written respiratory protection program must be
implemented meeting all the requirements of 29CFR1910.134, including training, fit testing and medical evaluation. In Canada,
CSA standard Z94.4 requirements must be met and/or requirements of the applicable jurisdiction, as appropriate. Misuse may
result in injury, sickness or death. For correct use, consult supervisor and User Instructions, or call 3M Technical Service in USA
at 1-800-243-4630 and in Canada at 1-800-267-4414.
Quick Start Guide: TR-800
NOTE: This sheet supplements, but does not replace, User Instructions. Always read and follow User Instructions.

3M Versaflo TR-800 Specifications

General

Product Type	Powered Air Purifying Respirator (PAPR)
Intrinsically Safe	Yes
Battery Type	Lithium-ion
Filter Type	Particulate, gas, and vapor filters
Product Series	Versaflo
Filter Options	Particulate, Gas and Vapor Filters
Standards	NIOSH approved

Summary

3M Versaflo TR-800 PAPR Quick Start Summary

Battery Charge and Connection

Confirm battery charge by pressing test button and attach battery pack securely to motor/blower.

Filter, Belt, and Airflow Setup

Attach filter/cartridge and belt, then confirm airflow sufficiency using the indicator.

Breathing Tube and Headtop Connection

Connect breathing tube to PAPR air outlet and headtop, ensuring secure connections.

Donning and Workplace Procedures

Inspect headtop for damage and don the PAPR according to workplace procedures.

TR-800 PAPR System Inspection and Assembly

System Component Inspection

Inspect motor/blower, battery pack, breathing tube, filter/cartridge, and headgear for damage.

Assembly and Flow Check

Assemble battery pack, filter/cartridge, and breathing tube to motor/blower and headgear.

Daily Operation and Post-Use Procedures

Perform Daily Flow Check

Check airflow daily using indicator TR-971 and perform low flow alarm test.

Donning the PAPR System

Turn on motor/blower, attach PAPR to wearer, and adjust headgear.

Post-Use Procedures

Turn off motor/blower, remove PAPR safely, clean, and charge battery.