3millID 9249 S. Broadway Building #200 Suite 826 Highlands Ranch CO 80129
+1 303 475 4972
sales@3millid.com
© 3millID
100-02640-A
www.3millid.com
MANUAL
3M
S-Gang
Keypad
7
KEY TONE
PIN CODES
*02
set AUDIBLE TONE on KEY PRESS
CARD TONE
PIN CODES
*03
set AUDIBLE TONE on CARD
PROX READ
PIN CODES
*04
set PROXIMITY READING
*020#
*021#
.....
.....
*02n#
example
*030#
*031#
.....
.....
*03n#
example
*040#
*041#
.....
.....
*04n#
example
The following instructions give a step-by-step procedure for accessing the many features
supported by this reader.
4.keypad programming guide
DISABLE(NO audio tone) (factory default)
ENABLE(audible tone on PIN entry)
To ENABLE the buzzer, enter: *021# once the reader has
been placed into programming mode.
During the entry of a buffered PIN you have the option of
making the reader issue a confirmation beep or an error
(triple-beep) on entering the PIN.
6
8
0
9
#
4
7
*
5
123
During the entry of a buffered PIN you have the option of
making the reader issue a confirmation beep or an error
(triple-beep) on presenting a CARD.
To ENABLE audio tone, enter: *031# once the reader has
been placed into programming mode.
DISABLE(NO audio tone) (factory default)
ENABLE(audible tone on presenting a card)
6
8
0
9
#
4
7
*
5
123
This programming command allows you to disable
transmission of the proximity card data from the reader.
The reader will still beep to indicate that it has read the card.
To DISABLE transmission of the card data, enter: *040#
once the reader has been placed into programming mode.
DISABLE(data will NOT be sent)
ENABLE(data WILL be sent) (factory default)
6
8
0
9
#
4
7
*
5
123
To Next Page
Loading...
Need help?
General