Placing print tray
Our printers use removable trays: for best results, some care is needed about keeping them clean and intact: for more
information revert to maintenance section.
To load printing tray into printer, just lean it over the heated print plate: magnets will align and lock automatically.
Tray printing surface needs to be clean and free from remains from previous prints: the film coating should be intact,
otherwise you should consider applying a new layer.
Each time you use a tray, be sure about the lower part of the tray (facing toward heated Z plate) to be perfectly clean.
Never use any kind of spray (lubricants, cleaners or hairspray) inside printer.
23
To Next Page
Loading...
