Octoprint configuration (print server)
• Connecto to the print server
◦ mouse and keyboard (USB)
◦ HDMI cable to connect to a TV/monitor
◦ power supply
• Turn on print server, after boot enter
User: pi
Password: raspberry
• At system prompt insert
startx
• When graphical user interface is loaded, at the right upper corner you sill see the familiar wifi icon.
Click on it to configure according to your router and networking standards.
If everything is OK, at next system boot you will be able to read the newtoking setup (IP number) of
your print server
41
To Next Page
Loading...
