much, you could prevent complete rotation of tube adapter during removal
9. Remove (unscrewing) the tube adapter
10. Detach the connector (5): grab the connector body to pull, do NOT pull the cables!
11. Release the locking screw (6)
12. Now all the extruder assy (7) can slide downwards from holding part.
13. Put back the (new?) extruder assy in the holding part, sliding it up (position will be higher than normal). Gently
lock the screw (6)
14. Put back on the tube adapter(4)
15. Plug in the electrical connector
16. Perform Z calibration of the nozzles
17. Plug in the PTFE piping(2)
18. Feed the filament to the extruder
19. Perform XY nozzle calibration
28
To Next Page
Loading...
